Apiary

Setting the second building on the hive: when put.

double-hulled hives solve many problems.

spring, when the family is small, bee honeycombs are engaged in building and collecting nectar.

While increasing the number of brood hive with a small amount of the family can begin to swarm.

This is indicated tab and expanding swarm queen cells the bees.

Increase the family and avoid swarming allow setting the second case on hive.

So, beekeeper saves energy and operating properly be used to increase the number brood.

The bees begin to swarm in that case, If the queen lays a lot of eggs, and places in the hive is missing.

When the second building to put the hive

Setting the second building is in the case, if the bees take 11 streets and house will 9 framework of the bee brood.

At that time removed from the hive lid and set the second building.

Beekeeper should provide enough wax and set the empty frame.

Usually the second case refers to basic per month medosbora.

If you've seen the new queen cells in the family, you can cut them. However, this does not always produce results.

It is necessary to give the family swarm and use this time to increase bees.

Ways to expand the hive dvuhkorpusnoho:

• both the top and bottom;
• only in upper case.

Usually Nest expand, using upper and lower compartments.

To do this, put the first building and the second placed in the center of the frame with open brood frames with two printed.

Also set Wax cell and empty. Young bees do not fly to collect honey, they feed and sisters waiting in the wings.

If the main trick is not long, cells and fully restored, removed them and placed the empty frame Wax.

This will create a land reserve for pasitsi.Vidbir honey from the second building is in the first half medosbora.

These cells re-inserted in the winter, they are a source of food for insects.

In their place is set Susz, which will again be filled with nectar.

The second building after the main shot medosbora, if the family is very small.

You can set the second case a simplified scheme. Instead of three frames of brood placed only one.

In this age of brood should be different. The edges put honey and ambrosia cells.

The lower body instead put Susz selected cells or frames with wax.

So, at the top of the bee hive will grow and gain strength, а в нижній – відбудовувати стільники або збирати нектар.

Once at the bottom of all cells are occupied, pereberetsya uterus at the top and begin laying eggs there.

Read more about installing the second building can be found, watching videos.

Read: Replanting females in colonies: how

What to do with a printed brood?

If sealed brood too much, Bees can begin to swarm.

This is due to the huge number of young and idle bees.

In order to prevent swarming bees, you need to remove a few frames with brood printed and a separate vidvodok.

Next, the main family strengthens these layers.